Custom Ring Sizing

It is always preferable to confirm your finger size with a professional jeweler. Request they use a "wide" finger sizer for class-ring sizing. If you cannot go to a jeweler to have your finger sized, the image below can be used as a do-it-yourself method.

Finger sizer

Ring Sizing Digram

In order to print the ring sizer above, be sure that your printer is set to 100%. Make sure that you have not reduced the print size in your printer 'page setup' area. You can verify that the sizer printed correctly by measuring it with a ruler; it should measure from A to B: 3 1/2 inches long.

Once you have printed the sizer, follow these directions to find your ring size:

  • Cut out the ring sizer.
  • Cut a slit for Slot "A"
  • With the numbers facing out, wrap the sizer around the finger where the ring will be worn.
  • Pull the pointed end Tab "B" through Slot "A" until the sizer is snug, making sure to allow size for the knuckle.
  • The number aligned with Slot "B" is your ring size.
  • If the measure lands between two numbers your size is a half size Ex: Between 5 and 6 ring size: 5.5. If half sizes are not available, order the next largest size.